EPA Laboratory Test Report

December 7, 2000 - CALIFORNIA ENVIRONMENTAL ENGINEERING
An EPA Approved Environmental testing Laboratory Using #2 diesel (home heating oil), in an air motionless area, three baseline readings were taken 30 seconds apart.

The HeatMAX device was installed and 10 minutes was allowed for stabilization of the conditioned fuel to reach the flame. Three test readings were taken 30 seconds apart and the result was an average increase in temperature of 56%!

	Baseline		With HeatMAX Installed
1.	243° F		326°F
2.	213°F		375°F
3.	224°F		357°F

"We have tried said system on our steam boilers, which are operating with fuel oil, under the supervision of our factory Engineering Department." "Saving percentage is 19%." "In addition to above; utilization of FuelMAX extends life of boilers by means of removing carbon residues inside boiler incinerator and flame pipes thus reducing the need for periodic maintenance." The factory Engineering Department recommends utilization of this system with all factory boilers, vehicles, and engines."
- Director General, Engineering
Shamsi Textile Industries